STEYR 4 CYLINDER User Manual

ELECTRICAL SYSTEM
Page ELECTRICAL SYSTEM - 84 Z001019/0_6_July 2008
SERVICE MANUAL MARINE ENGINES
06.10.04.07 Potentiometer Accelerator, B13
1 Disassemble indexing plate (ill.8+9/pos.1).
2 Remove plug housing (ill.8+9/pos.2).
3 Unscrew hexagon nut of accelerator lever (ill.8+9/
pos.3), remove lever.
4 Loosen 2 hexagon screws. Remove accelerator
(ill.8+9/pos.4).
06.10.04.06 Oil pressure sensor, B18
1 Remove plug housing.
2 Unscrew oil pressure sensor (ill.7/pos.1) from mount
(ill.7/pos.2).
ATTENTION: Collect running out motor oil in a
suitable vessel.
06.10.04.05 Rack position feedback sensor, B14
1 Remove retaining clip, remove plug housing
(ill.6/pos.1).
2 Disassemble control solenoid, refer to 03.08.01
3 Loosen 2 cylinder screws with hexagon socket (SW
3), remove sensor (ill.6/pos.2).
Assembly is done according to assembly
of control solenoid, refer to 03.08.
10.04 ill.6
2
1
1
2
10.04 ill.7
1
2
3
4
10.04 ill.8
Boost pressure sensor, B12
for engines 164 / 174 / 246 / 256 / 266 only
1 Remove cable strap, lift shackle at plug and pull off
plug.
2 Loosen clamp (SW6) and pull off hose.
3 Loosen union nut (SW17) by holding up at sensor
(SW32). Remove sensor
Assembly is done in reverse order off disassembly.
NOTE: Wetten the thread from the new sensor
with LOCTITE 243. Thigthen union
nut solid.
10.04 ill.5
ToC

STEYR 4 CYLINDER Specifications

General

Brand	STEYR
Model	4 CYLINDER
Category	Engine
Language	English