Z001019/0_8_Octobre 2011 Page GENERAL-21
GENERAL
SERVICE MANUAL MARINE ENGINES
ToC
B 2 Motor oil
To obtain the best engine performance and engine life, only motor oils of know manufacturers are to be used,
with ACEA, API service code and specified SAE viscosity. Refer to oil identification symbol on the container.
Initial filling quantity: 4 Cyl. engines 8,4 Litre (Oil filling, incl. 1l oil filter)
6 Cyl engines 10,4 Litre (Oil filling, incl. 1l oil filter)
Oil quantity between MIN. and MAX.
on dipstick 2,0 Litre
Oil change quantity: 4 Cyl. engines 7,0 Liter (without oil filter)
6 Cyl. engines 9,0 Liter (without oil filter)
Öil filter: ca. 1 Litre
Oil - specification, Minimum: API: CF or higher
ACEA: B4 - 02 or higher
Viscosity class: SYNTHETIC OIL 5W-50
SYNTHETIC OIL 10W-40
02.02 ill.1
02.02 ill.2
Recommended
engine oil: STEYR TURBO DIESEL ENGINE OIL - SAE 10W-40
SMO No. Z010058/0
Initial factory fill is a high quality break-in oil specified ACEA B4 - 02, SAE 5W-50. During the break
in period (20 hours), frequently check the oil level. Somewhat higher oil consumption is normal until piston rings
are seated. The oil level should be maintained between the minimum and maximum marks on the dipstick. The
space between the marks represents approximately 2 quarts (2 litres). For oil dipstick location, refer to
section Technical Data and Overview (A 4)
Refer to Service and Maintenance Chart (C 2) for
recommended oil change intervals.
Oil Identification Symbol
Motor oils are specified by ACEA, API
service code and SAE viscosity numbers.
These may be found on the label, top of can, or oil
identification symbol.
NOTE: Some motor oils have several ACEA / API quality
ratings.
The recommended ACEA /API service letter code
must be among these quality ratings.
ill.1 Top of Can
ill.2 Oil Identification Symbol
SAE
5 W-50
10 W-40
API
SERVICE CODE
CF
ACEA E7 or B4 - 02
FOR HEAVY DUTY
DIESEL ENGINES
ACEA E7 or B4-02
API CF
To Next Page
Loading...
Need help?
General
