Stihl MS 362 Manual

106 MS 362, MS 362 C
12.11 Fuel Intake
12.11.1 Pickup Body
Any impurities mixed with the fuel
are retained by the pickup body
(filter). The fine pores of the filter
eventually become clogged with
minute particles of dirt. This restricts
the passage of fuel and results in
fuel starvation.
In the event of problems with the
fuel supply system, always check
the fuel tank and the pickup body
first.
– Troubleshooting, b 3.6 or
b 3.7
Clean the fuel tank if necessary,
– Open the tank cap and drain the
tank.
– Pour a small amount of clean
gasoline into the tank. Close the
tank and shake the saw
vigorously.
– Open the tank again and drain it.
– Dispose of fuel properly in
accordance with environmental
requirements, b 1
– Open the tank cap.
: Use hook 5910 893 8800 to
remove the pickup body (1) from
the fuel tank.
Do not overstretch the fuel hose.
: Pull off the pickup body (1), check
it and replace if necessary.
– Reassemble in the reverse
sequence.
12.11.2 Fuel Hose
– Remove the shroud, b 6.4
– Remove the air guide shroud,
b 12.4
: Pull out the fuel hose (1) with
connector.
1
0001RA410 TG
1
0001RA411 TG
: Pull the fuel hose (2) off the
connector (1).
– Remove the pickup body,
b 12.11.1
: Pull the fuel suction hose (1) out
of the fuel tank.
: Inspect the fuel hose (1), fuel
suction hose (2) and connector
(3) and replace as necessary.
0001RA412 TG
1
2
0001RA413 TG
1
0001RA414 TG
2
3
1

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc