Stihl MS 362 - Tank Housing

107MS 362, MS 362 C
: Push the fuel hose (1) through
the bore (arrow) in the fuel tank.
: Line up the fuel suction hose (1)
and push it into the housing bore
– the flange must engage the
guide (arrow).
– Coat with STIHL press fluid,
b 15
0001RA415 TG
1
1
0001RA416 TG
Installing
: Push the fuel hose (1) onto the
connector (2) as far as stop.
Note position of the hose
– the flats (arrows) must be in
alignment.
: Push the fuel hose (1) with
connector into the fuel suction
hose (2).
0001RA417 TG
2
1
1
0001RA418 TG
2
: Use hook 5910 893 8800 to pull
the fuel suction hose (1) out of
the fuel tank.
Do not overstretch the fuel suction
hose.
– Fit the pickup body, b 12.11.1
– Close the tank cap.
12.11.3 Tank Housing
If a mounting thread for plastic
tapping screws is damaged, the
tank housing can be repaired by
fitting a thread insert.
– Drain the fuel tank, b 1
– Remove the handlebar, b 9.6
Machines with handle and
carburetor heating, b 9.7
– Remove cable on machines with
QuickStop Super, b .
– Remove the stop buffer, b 9.5
– Remove the control levers,
b 10.
1
0001RA419 TG