87MS 362, MS 362 C
: Press the cover (1) into the
recess until it snaps into place.
– Check adjustment of oil pump
and readjust if necessary – see
instruction manual.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
11.4 Valve
A valve is installed in the tank wall to
keep internal tank pressure equal to
atmospheric pressure. The valve
must be replaced if it is faulty.
– Open the oil tank cap and drain
the oil tank b 1.
: Use a 6 mm drift to carefully
drive the valve out of its seat in
the housing and into the oil tank.
0001RA320 TG
1
0001RA321 TG
: Remove the old valve (1) from
the oil tank.
Installing
Check correct installed position.
: Insert the valve in the housing
bore (arrow).
– Use a 6 mm drift to carefully
drive in the new valve from
outside – note installed depth.
219RA476 TG
1
0001RA322 TG
: Drive the new valve into the bore
to a depth of 1 +/- 0.1 mm (a).
– Reassemble all other parts in the
reverse sequence.
219RA479 TG
To Next Page
Loading...
