EasyManuals Logo

Stihl MS 362 Manual

Stihl MS 362
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
13MS 362, MS 362 C
3.6 Carburetor
Condition Cause Remedy
Carburetor floods; engine stalls Inlet needle not sealing
– foreign matter in valve seat or
cone
Remove and clean the inlet needle,
clean the carburetor
Inlet needle worn Replace the inlet needle
Inlet control lever sticking on
spindle
Check the inlet control lever and
replace if necessary.
Helical spring not located on nipple
of inlet control lever
Remove the inlet control lever and
refit it correctly
Perforated disc on diaphragm is
deformed and presses constantly
against the inlet control lever
Fit a new metering diaphragm
Metered diaphragm deformed Fit a new metering diaphragm
Poor acceleration Setting of low speed screw too lean Check basic carburetor setting,
correct if necessary
Setting of high speed screw too
lean
Check basic carburetor setting,
correct if necessary
Inlet needle sticking to valve seat Remove inlet needle, clean and
refit
Diaphragm gasket leaking Fit new diaphragm gasket
Metering diaphragm damaged or
shrunk
Fit a new metering diaphragm
Tank vent faulty Replace tank vent
Leak on fuel hose from tank to
carburetor
Seal connections or install new fuel
hose

Table of Contents

Other manuals for Stihl MS 362

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stihl MS 362 and is the answer not in the manual?

Stihl MS 362 Specifications

General IconGeneral
Displacement59.0 cm³
Powerhead Weight5.6 kg
Chain pitch3/8"
Vibration level (left/right)3.5/3.5 m/s²
Weight5.6 kg
Guide Bar Length40-50 cm (16-20 in)
Oil Capacity325 cc
Weight (without cutting equipment)5.6 kg
Oil tank volume325 cc

Related product manuals