Stihl MS 362 - AV Spring on Handlebar

69MS 362, MS 362 C
: Tighten down the screw (1) firmly.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
9.4 AV Spring on Handlebar
The AV spring is located between
the handle frame and cylinder.
– Remove the shroud, b 6.4
: Take out the screws (1) and
(arrows).
: Remove the complete AV spring
(2).
1
0001RA214 TG0001R215 TG
2
1
0001RA216 TG
1
2
: Unscrew the bearing plug (1) and
disconnect the retainer (arrow).
– Unscrew the spring (2) and pull
out the retainer (arrow).
– Inspect the bearing plug (1),
spring (2) and bracket (4) and
replace if necessary.
Installing
: Push the retainer (1), small nipple
first, into the bracket.
– Screw the spring onto the
bracket.
: Push the retainer (arrow) into the
bearing plug (1) and attach it.
0001RA217 TG
1
4
2
3
0001RA218 TG
1
0001RA216 TG
1
2
: Screw the bearing plug (1) into
the spring as far as stop.
: Push the complete AV spring (1)
into the handlebar.
: Insert the screws (arrows) and
tighten them down firmly.
: Coat the screw (2) with Loctite, fit
it and tighten it down firmly, b 15
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
0001RA121 TG
1
2