Stihl MS 362 Manual

88 MS 362, MS 362 C
12. Fuel System
12.1 Air Filter
Dirty air filters reduce engine power,
increase fuel consumption and
make starting more difficult. The air
filter should be checked when there
is a noticeable loss of engine power.
– See also Troubleshooting,
b 3.6, b 3.7
– Remove the shroud, b 6.4
: Pull off the prefilter (1) with the
handle (arrow).
: Lift the retaining tab (1) a little and
remove the air filter (2).
– Check the air filter and prefilter
and clean or replace if necessary
– see instruction manual.
– Reassemble in the reverse
sequence.
0001RA325 TG
1
0001RA326 TG
1
2
12.2 Baffle
– Remove the air filter, b 12.1
: Unscrew the nuts (arrows).
– Remove the baffle (1).
– Check the baffle and replace it if
necessary
– Reassemble in the reverse
sequence.
– Tightening torques, b 2.5
12.3 Filter Base
– Remove the air filter, b 12.1
– Remove the baffle, b 12.2
– Remove the choke rod,
b 10.3.3
– Disconnect the ground wire from
the contact spring, b 7.7.4.
0001RA327 TG
1
: Pull the short circuit wire (1) out
of the guides (arrows).
– Pull the ring terminal off the pivot
pin (2).
: Pull the filter base (1) off the pivot
pin (arrow) first.
: Then pull the filter base (1) off the
pivot pin (arrow) at the other side.
: Remove the filter base (1).
– Check the individual parts and
replace if necessary.
0001RA170 TG
1
0001RA328 TG
1
1
0001RA331 TG

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc