124 MS 362, MS 362 C
No. Description Part No. Application Rem.
17 Mounting plate for assembly
stand
5910 850 1650 Clamping machine to assembly stand
18 Ignition system tester, ZAT 4 5910 850 4503 Testing ignition system
19 Ignition system tester, ZAT 3 5910 850 4520 Testing ignition system
20 Torque wrench 5910 890 0302 0.5 to 18 Nm
21 Torque wrench 5910 890 0312 6 to 80 Nm
22 Installing tool 12 5910 890 2212 Installing hookless snap rings in piston
23 Screwdriver 5910 890 2304 Adjusting carburetor
- Setting disk 5910 893 6600 Add-on for screwdriver (adjusting
carburetor)
24 Screwdriver bit, T 27 x 150 5910 890 2400 IS-P screws (4 mm)
25 Hook 5910 890 2800 Detaching springs on clutch shoes
26 Assembly stand 5910 890 3100 Holding saw for repairs
27 Puller 5910 890 4400 Removing oil seals
- Jaws (No. 3.1) 0000 893 3706 Removing oil seal(s)
28 Puller 5910 890 4500 Removing limiter caps
29 Stud puller M8 5910 893 0501 Removing bar mounting studs
30 Screw sleeve 5910 893 2420 Installing crankshaft
31 Socket, 13 mm, long 5910 893 2804 Removing and installing
decompression valve
32 Hook 5910 893 8800 Removing pickup body
Remarks:
1) Use for releasing only.