Stihl MS 362 Manual

56 MS 362, MS 362 C
The wire must be laid straight.
: Push the short circuit wire (1) into
the guides (arrows).
– Install the filter base, b 12.3
: Push the ring terminal (1) onto
the pivot pin (arrow) as far as
stop.
: Push the short circuit wire (1) into
the guides (arrows).
Position the short circuit wire so that
it forms a loop and can move along
with the switch shaft.
0001RA174 TG
1
0001RA178 TG
1
0001RA170 TG
1
: Check that short circuit wire is
properly seated, push it fully into
the guide (arrow) if necessary.
: Fit the ring terminal (1) of the
ground wire on the pin (2) and
swing it down.
: The ring terminal (1) must
engage behind the lug (2).
0001RA185 TG0001RA203 TG
2
1
0001RA204 TG
2
1
– Fit the contact spring, b 7.7.4
: Push the ground wire (1) into the
guide (arrow).
– Reconnect the choke rod,
b 10.3.3
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
7.7.3 Ground Wire
A faulty ground wire may impair or
prevent operation of the short circuit
wire.
The ground wire is combined with
the short circuit wire in a wiring
harness. If damaged, the complete
wiring harness must be replaced
– Check for contact and continuity
and replace the short circuit wire
if necessary, b 7.7
0001RA205 TG
1

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc