Stihl MS 362 Manual

53MS 362, MS 362 C
Installing
– Use a pointed tool to pierce the
center of the new ignition lead’s
insulation, about 15 mm from the
end of the lead.
: Pinch the hook of the leg spring
into the pierced hole in the center
of the lead (arrow).
– Coat the inside of the spark plug
boot with
STIHL press fluid, b 15
: Hold the ignition lead and leg
spring together and push them
into the spark plug boot.
165RA188 TG0001RA503 TG
: Make sure the leg spring (arrow)
locates properly inside the spark
plug boot.
: Use a pointed tool to pierce the
center of the other end of the
ignition lead which screws into
the module.
Before installing the ignition lead, fill
the high voltage output with STIHL
multipurpose grease b 15.
Do not use either graphite grease or
silicone insulating paste.
0001RA504 TG165RA191 TG
– Screw the ignition lead into the
ignition module.
: Push the grommet (1) into
position.
– Install the ignition module and set
the air gap between the module
and flywheel,
b 7.6
– Reassemble all other parts in the
reverse sequence.
7.6 Flywheel
– Remove the shroud, b 6.4
– Use locking strip to block the
piston, b 4
: Unscrew the flywheel nut (1).
0001RA164 TG
1
0001RA165 TG
1

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc