Stihl MS 362 Manual

33MS 362, MS 362 C
6. Engine
6.1 Muffler
Always check and, if necessary,
repair the fuel system, carburetor,
air filter and ignition system before
looking for faults on the engine.
– Troubleshooting, b 3
– Remove the shroud, b 6.4
Before removing the muffler, set the
piston to top dead center to ensure
that no dirt falls into the cylinder.
: Pry out the plug (1).
– Do not refit old plugs, always fit
new ones.
: Take out the screws (1) and (2).
: Remove the muffler (3), check
and replace if necessary.
0001RA074 TG
1 1
0001RA075 TG
2
3
11
2
: Remove the exhaust gasket (1).
– Remove and install the spark
arresting screen – see instruction
manual.
Installing
– Hold the machine upright.
: Inspect and clean the sealing
faces (arrows) and remove any
gasket residue.
Always replace components with
damaged sealing faces.
0001RA076 TG
1
0001RA079 TG
– Position the exhaust gasket (1)
so that the warts (arrows) point
towards the cylinder.
: Fit the exhaust gasket (1) and
line it up with the warts (arrows)
against the cylinder exhaust port.
: Carefully place the muffler (1) in
position.
: Check the position of the gasket
and fit the screws (2).
– Do not tighten down the
screws (2) yet.
0001RA080 TG
1
0001RA081 TG
2
1
2

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc