EasyManuals Logo

Stihl MS 362 Manual

Stihl MS 362
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #99 background imageLoading...
Page #99 background image
98 MS 362, MS 362 C
Lever (1) must butt against lever (2)
and engage lever (3).
Lever (5) must engage lever (2) for
cold and warm starts
– the choke lever (5) returns to the
idle position when the throttle is
opened.
Screw (4) must be tightened
down firmly.
The torsion springs (arrows) must
be preloaded and attached to the
levers.
0001RA374 TG
1
2
3
5
4
0001RA466 TG
12.6.5 Levers on Throttle Shaft
Remove the carburetor, b 12.5
Carburetor troubleshooting,
b 3.6
: Take out the screw (1).
Relieve tension of the torsion
spring (2) and remove the lever
(3).
Pull off the torsion spring (2) and
lever (4).
Check the individual parts and
replace if necessary.
Installing
: Push the lever (1) onto the
throttle shaft as shown (arrow).
0001RA375 TG
2
4
3
1
0001RA376 TG
1
: Fit the torsion spring (1) so that
its leg locates against the lever
(arrow).
: Attach the torsion spring to the
lever (arrow).
: Place the lever (1) in position and
tighten the screw (2) moderately
– it must still be possible to turn
the lever.
: Hold the lever (2) steady.
: Rotate the lever (1) clockwise
until it butts against the stop on
lever (2) and engages the end of
the throttle shaft.
0001RA377 TG
1
0001RA378 TG
1 2
0001RA379 TG
1
2

Table of Contents

Other manuals for Stihl MS 362

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stihl MS 362 and is the answer not in the manual?

Stihl MS 362 Specifications

General IconGeneral
Displacement59.0 cm³
Powerhead Weight5.6 kg
Chain pitch3/8"
Vibration level (left/right)3.5/3.5 m/s²
Weight5.6 kg
Guide Bar Length40-50 cm (16-20 in)
Oil Capacity325 cc
Weight (without cutting equipment)5.6 kg
Oil tank volume325 cc

Related product manuals