Stihl MS 362 - Page 93

92 MS 362, MS 362 C
: Push the air guide shroud's lugs
(1) between the ribs (arrow) on
the crankcase.
– Push the air guide shroud fully
home.
: Make sure the protective tube (1)
covers the opening (arrow).
: Fit and tighten down the screws
(1) firmly.
0001RA338 TG
1
0001RA339 TG
1
0001RA340 TG
1
1
: Position the generator wire (1) so
that the insulating tube (2) is
against the guide (3).
– Fit the generator wire in the
guide (3).
: Position the wire (1) so that the
insulating tube (2) is against the
guide (3).
– Fit the wire in the guide (3).
0001RA265 TG
2
1
3
0001RA264 TG
2
3
1
: Push the wire (1) into the guide
(arrow).
: Push the connector sleeve (2)
into the heater switch.
– Install all other parts as in the
standard version.
– Tightening torques, b 2.5
12.5 Carburetor
– Remove the filter base, b 12.3
– Open the fuel tank cap and drain
the fuel tank.
– Collect the fuel in a clean
container, b 1
Disconnect the fuel hose only when
the tank cap is open.
Machines with Handle Heating
: Remove the heating element (1).
0001RA263 TG
1
2
0001RA354 TG
1