Stihl MS 362 Manual

91MS 362, MS 362 C
: Pull the wires out of the guides
(arrows).
: Take out the screws (arrows).
: Remove the air guide shroud (1)
and push the fuel hose (2)
through the opening at the same
time.
: Pull the wires out of the rubber
grommet.
0001RA355 TG0001RA242 TG
1
2
0001RA259 TG
: Remove the rubber grommet (1)
by pushing it into the air guide
shroud.
Installing
: Push the rubber grommet (1),
tapered end first, into the
housing.
: The flange (arrow) must locate
properly in the hole.
0001RA343 TG
1
0001RA344 TG
1
0001RA345 TG
: Push wire (1) and then wire (2),
connector first, through the
grommet.
– Pull the full length of generator
wire (3) into the air guide shroud.
: Push the fuel hose (1) through
the opening (arrow).
: Fit the air guide shroud (1) over
the intake manifold (2), re-
positioning the fuel hose (3) at
the same time.
0001RA260 TG
2
1
3
0001RA336 TG
1
0001RA337 TG
1
2
3

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc