Stihl MS 362 Manual

119MS 362, MS 362 C
13.7.2 Test Connections and Test Values
– The pin and socket connections
of the wires in the rear handle
must be disconnected to test the
individual components.
1)
Pull out wire for this purpose
Component Ohmmeter connection
(use either test lead)
Resistance Ω If faulty
Lead 1 Lead 2 Spec. Actual Cause Remedy
Switch Switch
terminal
1)
Switch
housing
< 0.5 - Switch faulty Replace switch
Heating element in
rear handle
Connector
on wire
from
heating
element
Connector
on wire
from
heating
element
1.6 1.5 - 2.0 Heating element
OK
- Break in wire,
heating element
damaged
Install new heating
element or
repair insulation
0 Short circuit –
damaged insulation
Heating element in
handlebar
Connector
on wire
from
handlebar
heating
element
Connector
on wire
from
handlebar
heating
element
6.4 6.0...8.0 Heating element
OK
- Break in wire,
heating element
damaged
Install new
handlebar
0 Short circuit –
damaged insulation
Repair insulation

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc