27MS 362, MS 362 C
– Check the brake cable (1) and
retainer (2), replace if necessary
Disassembling the brake cable
and retainer
: Loosen the clamp screw (1) and
take out the adjusting screw (2).
– Pull out the brake cable (3) and
replace the retainer.
0001RA047 TG
2
1
0001RA048 TG
3
2
1
Installing
: Push the long hook (1) of the
brake cable into the hole (arrow)
and screw home the adjusting
screw (2) as far as stop.
: Push the short hook of the brake
cable (1) up through the slot
(arrow) from below.
: Push the short hook (1) through
the hole (arrow).
0001RA049 TG
2
1
0001RA046 TG
1
0001RA050 TG
1
: Push the brake cable (1) into the
bore (arrow) in the brake lever.
: Push the brake cable grommet
(1) into the housing bore (arrow)
until it is properly seated.
: Push the lugs of the brake cable
retainer (1) into the seats
(arrows) as far as stop.
– Insert and tighten down the screw
(2) firmly.
1
0001RA497 TG
0001RA052 TG
1
0001RA053 TG
1
2
To Next Page
Loading...
