Stihl MS 362 Manual

43MS 362, MS 362 C
– Wear protective gloves
to reduce risk of burn injury.
– Heat the inner bearing race to
about 150°C (300°F).
– Position the clutch side of the
crankcase on the straight
crankshaft stub and the screws.
: Push the crankcase fully home.
This operation must be carried out
very quickly because heat is
absorbed by the crankshaft, and the
inner bearing race shrinks.
If it is not possible to heat the inner
bearing race, use service tool
5910 890 2205 to install the
crankcase.
– Coat the straight stub of the
crankshaft with oil.
– Position the clutch side of the
crankcase on the straight
crankshaft stub and the two
screws.
0001RA128 TG
– Screw the spindle
(counterclockwise, left-hand
thread) fully into the service tool.
: Screw the threaded sleeve (1)
5910 893 2409 onto the spindle
as far as stop – left-hand thread.
: Apply the screw sleeve to the
crankshaft stub (arrow) and push
the service tool over the bar
studs.
165RA133 TG
1
0001RA494 TG
: Hold the crankshaft steady and
rotate the spindle
counterclockwise to screw the
screw sleeve onto the crankshaft
stub.
– Release the crankshaft. Hold the
service tool steady and continue
turning the spindle until the tool
butts against the crankcase.
– Fit the sprocket cover mounting
nuts on the bar studs and screw
them down finger-tight.
: Turn the spindle (1)
counterclockwise until the
crankcase locates against the
guide sleeves.
0001RA129 TG0001RA130 TG
1

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc