Stihl MS 362 Manual

66 MS 362, MS 362 C
Make sure that the rewind spring (1)
is properly seated and the outer
anchor loop is engaged on the lug
(arrow). If necessary, use suitable
tools to push the rewind spring fully
into its seat in the fan housing.
If the rewind spring has popped out,
refit it in the fan housing as follows:
– Arrange the spring (1) in its
original position.
: Fit the anchor loop in its seat
(arrow) in the fan housing.
219RA428 TG
1
0001RA199 TG
1
: Fit the rewind spring (1)
clockwise in the housing.
– Hold the spring windings so that
they cannot pop out.
Make sure that the rewind spring (1)
is properly seated. If necessary, use
suitable tools to push the rewind
spring fully into its seat in the fan
housing
– Secure the spring so that it
cannot pop out.
– Install the rope rotor, b 8.4
– Reassemble all other parts in the
reverse sequence.
1
0001RA200 TG

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc