Stihl MS 362 - Page 82

81MS 362, MS 362 C
: Remove the handle molding (1).
: Take the throttle rod (1) out of the
guide (arrow) and disconnect it
from the throttle trigger (2).
: Use a drift (2) to drive out the
pin (1).
0001RA288 TG
1
0001RA289 TG
2
1
0001RA290 TG
1
2
: Remove the throttle trigger (1)
with torsion spring (2).
– Check the throttle trigger (1) and
torsion spring (2) and replace if
necessary
Installing
: Attach the torsion spring (1) to
the trigger (2) – note the installed
position (arrow).
0001RA291 TG
2
1
0001RA292 TG
1
2
0001RA293 TG
1
2
: Place the throttle trigger (1) in the
handle and line up the holes in
the trigger and handle.
: Use a drift (2) to center the
throttle trigger (1).
: Drive home the pin (3) until it is
recessed by same amount at
both sides.
: Attach the throttle rod (1) to the
throttle trigger (2) and fit it in the
guide (arrow).
0001RA306 TG
1
2
0001RA294 TG
3 1
0001RA295 TG
2
1