92
X Z
Y
Z (min. 50)
Z (min. 800)
Z
(min. 50)
H
min
— H
max
Hmin — Hmax
[mm]
995 — 1045
895 — 945
795 — 845
695 — 745
595 — 645
495 — 545
355 — 405
270 — 320
EN/01.2019/G22 © STULZ GmbH – all rights reserved
ec tower technical manual
Connecting the bars (View from below)
Mounting
Raised floor stand
Z = Limit of distance
area of the raised floor supports.
distance of 50 mm must be respected. The gap
between wall and floor stand must be closed by
tin stripes.
raised floor (X and Y) 10 mm longer than the
raised floor stand dimensions.
least be 15° and must not have any contact
to the raised floor stand, which could result in
bone-conduction.
down the supports!).
raised floor 7 mm higher than the raised floor
plates, as the mafund plates are compressed by
Raised floor connection
for details, see next page
Recommended concrete
foundations (no floor finish)
Raised floor
Raised floor stand
Peripheral seal
Raised floor support
Upper edge of
rough floor
Unit width
General design of the raised foor stand
To Next Page
Loading...
