Sun Microsystems SPARCstation 10 - Page 143

TABLE 12–2 SCSI Target ID Jumper Settings
Drive Position Target ID Jumper Settings SCSI Address
0
(middle of chassis)
A0 installed
A1 installed
A2 not installed
3
1
(corner of chassis)
A0 installed
A1 not installed
A2 not installed
1
Figure 12–7 SCSI Addresses of Both Disk Drives
3. Verify that the configuration jumpers are correctly set. See Figure 12–8 and
Table 12–3.
Hard Disk Drives 127