Chapter 2 Setting Up XSCF 2-119
Note – When you delete the system board, please confirm the domain status, the
system board status, the device usage status on the system board, and also the
processes usage that are bound to the CPU or are accessing I/O devices. Then
confirm whether you should be able to delete the system board. Remember that
CPU/Memory Board unit resources also define the I/O resources, so deleting one
resource will affect the other. For details about operating the XSB while the Solaris
OS is running, and for details about DR messages, see the Dynamic Reconfiguration
User’s Guide.
6. Use the showboards(8) command to confirm that the XSB has been deleted
from the domain.
Moving a System Board From One Domain to Another
â– Command operation
1. Use the showdcl(8) command to display DCL information.
2. Use the setdcl(8) command to define the LSB of a new domain.
XSCF> showboards –va
XSB R DID(LSB) Assignment Pwr Conn Conf Test Fault COD
---- - -------- ----------- ---- ---- ---- ------- -------- ----
00-0 02(00) Assigned n n n Passed Normal n
01-0 02(07) Assigned n n n Passed Normal n
01-1 SP Available n n n Passed Normal n
01-2 02(09) Assigned n n n Passed Normal n
01-3 02(10) Assigned n n n Passed Normal n
XSCF> showdcl –a
DID LSB XSB Status
02 Powered Off
00 00-0
07 01-0
08 01-1
09 01-2
10 01-3
<Example> In domain ID 1, specify XSB#01-0 for an LSB#00, XSB#01-1
for an LSB#01, XSB#01-2 for an LSB#02, XSB#01-3 for an LSB#03.
XSCF> setdcl -d 1 -a 0=1-0 1=1-1 2=1-2 3=1-3
To Next Page
Loading...
Need help?
General
