Supermicro SSE-G24-TG4 - Protected Ports

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-70
Protected Ports
Clicking on the Protected Ports tab brings up the PROTECTED PORTS page (Figure 5-54).
The P
ROTECTED PORTS page allows configuration of the port specific protected
parameters. You can choose between non-protected or protected for a port. If you
choose a protected port, it can be a standalone or a single group member. The
parameters for this page are shown in Table 5-43.
Multicast Level This parameter allows you to specify the multicast packets per second.
The following parameters are configurable for Egress Rate Limiting.
Egress Port Rate
Limit
This parameter allows you to specify the egress limit of packets per second.
Egress Port Burst
Size
This parameter allows you to specify the egress limit of packet burst size.
Figure 5-54. Protected Ports Page
Table 5-43. Protected Ports Page Parameters
Parameter Description
Port Port number.
Port Mode
This helps to configure the mode as Normal or Protected port or Protected
Group.
Group ID
Choose the group identifier. This is enabled only in the Protected Group mode. 0
means the standalone protected port.
Table 5-42. Storm Control/Rate Limiting Page Parameters (Continued)
Parameter Description