1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-44
Alarm
Clicking the ALARM tab brings up the RMON ALARM CONFIGURATION page (Figure 5-32),
which configures RMON Alarm paramters. The parameters for this page are shown in
Table 5-25.
Figure 5-32. RMON Alarm Configuration Page
Table 5-25. RMON Alarm Configuration Page Parameters
Parameter Description
Index
This parameter specifies the table index. This value must be in the range from 1
to 65535.
Interval
This parameter specifies the time interval for which the alarm monitors the
variable. This value must be in the range from 1 to 4294967296.
Variable This parameter specifies the MIB object on which the alarm is set.
Sample Type
You can set this parameter to an Absolute Value or as just an Incremental Value
of the timer.
Rising Threshold
If the startup alarm is set as Rising Alarm and this threshold is reached, an alarm
is raised. This value ranges between 0 and 2147483647.
Falling Threshold
If the startup alarm is set as Falling Alarm and this threshold is reached, an alarm
is raised. This value ranges between 0 and 2147483647. The falling threshold
must be less than the rising threshold.
Rising Event Index
Indicates the index of the event to be raised when the R
ISING THRESHOLD is
reached. This value must be in the range from 0 to 65535.
To Next Page
Loading...
