1/10 and 10-Gigabit Layer 2/3 Ethernet Switches
A-8
Installing the Switch into a Rack
Use the procedure and Figure A-5 below to install the switch into a rack.
Installing the Switch
1. Confirm that inner rails have been secured to the switch.
2. Confirm that the outer rails are installed on the rack.
3. Align the ends of the inner rails on the switch with the front of the outer rails on the
rack.
4. Slide the inner rails into the outer rails, keeping the pressure even on both sides
(you may have to depress the locking tabs when inserting). When the switch has
been pushed completely into the rack, you should hear the locking tabs click into the
locked position.
5. (Optional) Insert and tighten the thumb screws which secure the front of the switch
to the rack.
Figure A-5. Installing the Switch into a Rack
To Next Page
Loading...
