EasyManua.ls Logo

Supermicro SSE-G24-TG4 - Ipv6 Interface

Supermicro SSE-G24-TG4
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-117
Chapter 5: Web Based Management Utility
IPv6 Interface
Clicking the IPV6 INTERFACE tab brings up the IPV6 INTERFACE SETTINGS page
(Figure 5-96), which displays the various parameters for the IPv6 Interface. The
parameters for this page are shown in Table 5-78.
Routing Protocol
This parameter indicates the routing protocol through which the route was
learned, if not manual. This cannot be configured.
Gateway This parameter specifies the Next Hop Gateway to reach the IP address.
Interface This parameter indicates the outgoing interface.
Distance (Metric)
This parameter denotes metric value of the destination. It should be in a range
from 1 to 4294967295.
Figure 5-96. IPv6 Interface Settings Page
Table 5-78. IPv6 Interface Settings Page Parameters
Parameter Description
Port This parameter specifies the Index of the VLAN interface.
Admin This parameter indicates the Administrative Status of IPv6 on the Interface.
Oper
This parameter specifies the Operational Status of IPv6 on the given Interface,
which is a read-only field.
RA Status This parameter indicates the Router Advertisement status on the Interface.
Table 5-77. IP6 Route Configuration Page Parameters (Continued)
Parameter Description

Table of Contents

Other manuals for Supermicro SSE-G24-TG4

Related product manuals