Supermicro SSE-G24-TG4 - Separating the Sections of the Rails; Installing the Inner Rails

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches
A-4
Separating the Sections of the Rails
The CSE-PT52L rail kit ships with the front inner rail attached to the front outer rail.
These must be separated prior to installation in the rack. Use the procedure below to
separate the rails.
Separating the Rails
1. Separate the inner rail from the outer rail by depressing the black plastic flange
inside the inner rail. This will release the outer rail.
2. Silde the inner rail forward and out of the outer rail.
3. The CSE-PT52L rail kit also includes a set of inner rail extensions. Only the inner
rails are required and you may discard the inner rail extensions.
Installing the Inner Rails
Use the procedure below and Figure A-2 to install the inner rails.
Figure A-1. Identifying the Sections of the Rack Rails
Inner Rail
Inner Rail Extension
(Discard)
Outer Rail Front Bracket
Outer Rail Rear Bracket