5-25
Chapter 5: Web Based Management Utility
Clicking the LOGGING tab brings up the SYSLOG CONFIGURATION page (Figure 5-15),
which allows you to configure logging parameters. The parameters for this page are
shown in Table 5-9.
ACL
The ACL link allows you to configure the Access Control List for the switch. You can
configure ACL on the following three pages:
• MAC ACL
• IP Standard ACL
• IP Extended ACL
Table 5-9. Syslog Configuration Page Parameters
Parameter Description
Syslog This parameter enables or disables the Syslog feature.
Server IP Address
This parameter specifies the Syslog server IP address. Make sure the Server IP
is reachable.
Buffer Size The buffer size is specfied in log entries. Max entries buffered is 200.
Timestamp
This parameter allows you to enable or disable the adding of a time stamp to the
log messages.
Console Log This parameter allows you to enable or disable logging to the console.
MAC Address Log
Enable or disable logging of the MAC address table update in syslog. By default
MAC address logging is disabled.
Facility
This parameter allows you to select supported facilities. The switch supports
syslog standard supported facilities
LOCAL0, LOCAL1, LOCAL2, LOCAL3, LOCAL4,
LOCAL5, LOCAL6, LOCAL7 and USER.
Traps
This parameter helps you to select a particular trap type. The following types of
traps are supported A
LERTS, CRITICAL, DEBUGGING, EMERGENCIES, ERROR,
I
NFORMATIONAL, NOTIFICATION and WARNINGS.
File Max Size Specifies the maximum size of the file entries. The default is 4096.
File Min Size Specifies the minimum size of the file entries. The default size is 2048.
Buffer Entries Displays the currently available number of log entries in syslog buffers.
File Entries Displays the currently available number of log entries in syslog files.
To Next Page
Loading...
