Supermicro SSE-G24-TG4 - Candidate Rps

5-185
Chapter 5: Web Based Management Utility
Candidate RPs
Clicking the CANDIDATE RPS tab brings up the CANDIDATE RP CONFIGURATION page
(Figure 5-159). The parameters for this page are shown in Table 5-136.
Message Interval
This parameter configures the time interval between two successive messages
being sent by PIM on this interface. The allowed ranges are 1 to 255. The default
value is 60 seconds.
CBSR Preference
This parameter indicates the preference value for the local interface as a
candidate bootstrap router. The allowed value ranges between -1 and 255. The
default value is -1.
LAN Prune Delay This parameter specifies the prune delay, which can be enabled or disabled.
Join Prune Interval
(Seconds)
This parameter specifies the time interval between two successive Join/Prune
messages being sent by PIM on this interface.
CBSR Preference
This parameter indicates the preference value for the local interface as a
candidate bootstrap router.
Row Status This parameter indicates the operational status of the entry.
Figure 5-159. Candidate RP Configuration Page
Table 5-135. PIM Interface Configuration Page Parameters (Continued)
Parameter Description