1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-250
RP Set Info
Clicking the RP SET INFO tab brings up the PIM RP INFORMATION page (Figure 5-213),
which displays PIM RP information. The parameters for this page are shown in
Table 5-187.
Figure 5-213. PIM RP Information Page
Table 5-187. PIM RP Information Page Parameters
Parameter Description
Group This parameter specifies the group address.
Mask This parameter specifies the mask.
Candidate RP This parameter specifies the candidate RP.
Hold Time This parameter specifies the Hold time in seconds.
Expiry Time This parameter specifies the expiry time in seconds.
Component This parameter specifies the component identifier.
To Next Page
Loading...
