Supermicro SSE-G24-TG4 - Interface Conf; Rip; Basic Settings

5-127
Chapter 5: Web Based Management Utility
Interface Conf
Clicking the INTERFACE CONF link brings up the DHCP RELAY INTERFACE CONFIGURATION
page (Figure 5-106), which allows you to configure the DHCP relay for VLANs. The
parameters for this page are shown in Table 5-88.
RIP
The RIP link opens the following links for configuration of RIP protocol:
• Basic Settings
• Interface
• Neighbors
• Security
• Summarization
Figure 5-106. DHCP Relay Interface Configuration Page
Table 5-88. DHCP Relay Interface Configuration Page Parameters
Parameter Description
VLAN Interface This parameter specifies the VLAN Interface name.
Circuit ID
This parameter specifies the DHCP Relay Circuit identifier. The allowed value
ranges between 1 and 2147483647.
Remote ID This parameter specifies the Remote identifier.