5-31
Chapter 5: Web Based Management Utility
SNMP
Clicking the SNMP link brings up the SNMP AGENT CONTROL SETTINGS page
(Figure 5-20). SMIS supports the SNMP Agent or SNMP AgentX Sub-agent. The
SNMP Agent or AgentX Sub-agent can be enabled or both can be disabled.
The SNMP Agent provides the following sub-page configurations shown in the table
below.
Figure 5-20. SNMP Agent Control Settings Page
Table 5-14. SNMP Agent Configuration Pages
Configuration
Page
Description
Community
This page allows you to configure the SNMP community including the
COMMUNITY INDEX, NAME, SECURITY NAME, CONTEXT NAME, TRANSPORT TAG and
S
TORAGE TYPE.
Group
This page allows you to configure SNMP groups including GROUP NAME,
S
ECURITY NAME, SECURITY MODEL and STORAGE TYPE.
Group Access
This page allows you to configure SNMP group’s access parameters including
G
ROUP NAME, SECURITY MODEL, SECURITY LEVEL, STORAGE TYPE, AND READ,
W
RITEand NOTIFY VIEW.
View
This page allows you to configure an SNMP view tree including VIEW NAME, SUB
T
REE, MASK, TYPE OF THE VIEW and STORAGE TYPE.
Target Address
This page allows you to configure the SNMP target including T
ARGET NAME,
T
ARGET IP, TRANSPORT TAG, PARAM and STORAGE TYPE.
To Next Page
Loading...
