Supermicro SSE-G24-TG4 - Neighbors

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-130
Neighbors
Clicking the NEIGHBORS tab brings up the RIP NEIGHBOR LIST page (Figure 5-109), which
is used to configure the RIP neighbors, by configuring their IP address.
The single parameter for this page is IP A
DDRESS, which specifies the IP Address of the
neighbor router to which the unicast update has to be sent.
Update Timer
This parameter specifies the time interval between successive RIP updates. The
allowed value ranges between 10 and 3600. The default value is 30.
Garbage Timer
This parameter specifies the time interval after which the invalid routes will be
removed from the routing table. The allowed value ranges between 120 and 180.
The default value is 120.
Figure 5-109. RIP Neighbor List Page
Table 5-90. RIP Interface Page Parameters (Continued)
Parameter Description