1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-10
System Settings
The following pages can be accessed through the System Settings link:
• System Settings
• System Version
System Settings
Clicking the SYSTEM INFORMATION tab brings up the SYSTEM SETTINGS page (Figure 5-2).
This page provides system related information and also helps you configure system
specific parameters. Table 5-2 lists the parameters found on this page.
Figure 5-2. System Settings Page
Table 5-2. System Information Page Parameters
Parameter Description
Device Name
Assigns a name to identify this device – 15 Characters input limit. The
factory default is SMIS.
Switch Base MAC Address This displays the MAC Address of the switch.
Serial Number This displays the serial number of the switch.
SNMP Engine ID
Sets the SNMP engine ID with 5 to 32 hexadecimal characters separated
by dots for the local or remote SNMP engine. A restart of the switch
required if these values are changed. The factory default is
80.00.08.1c.04.46.53
Device Contact
Assigns a contact person's name with a 255-character input limit. The
factory default is http://www.supermicro.com/support.
To Next Page
Loading...
