1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-132
Summarization
Clicking the SUMMARIZATION tab brings up the RIP INTERFACE SPECIFIC ADDRESS
S
UMMARIZATION page (Figure 5-111). The parameters for this page are shown in
Table 5-92.
RIPng
The RIP6 link allows you perform RIPv6 related configuration for the switch. This can be
accomplished through the following two pages:
• RIP6 Interface
• Filters
Figure 5-111. RIP Interface Specific Address Summarization Page
Table 5-92. RIP Interface Specific Address Summarization Page Parameters
Parameter Description
Interface
This parameter specifies the Interface ID for which the RIP aggregate address
needs to be configured.
Aggregate Address This parameter specifies the aggregate address.
Subnet Mask This parameter specifies the mask of the aggregate address.
To Next Page
Loading...
