1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-134
Filters
Clicking the FILTERS tab brings up the RIP6 FILTER CONFIGURATION page (Figure 5-113).
The parameters for this page are shown in Table 5-94.
OSPF
The OSPF link allows you to configure the OSPF protocol through the following pages:
• Basic Settings
• Area
• Interface
• Virtual Interface
• Neighbor
• RRD Route
• Aggregation
• AsExtAggregation
Figure 5-113. RIP6 Filter Configuration Page
Table 5-94. RIP6 Filter Configuration Page Parameters
Parameter Description
Filter Address This parameter specifies the FILTER ADDRESS for the RIP6 interface.
Filter Type This parameter specifies the FILTER TYPE for which RIP6 needs to be configured.
To Next Page
Loading...
