Supermicro SSE-G24-TG4 - Page 187

5-135
Chapter 5: Web Based Management Utility
Basic Settings
Clicking the BASIC SETTINGS tab brings up the OSPF BASIC SETTINGS page
(Figure 5-114). The parameters for this page are shown in Table 5-95.
Figure 5-114. OSPF Basic Settings Page
Table 5-95. OSPF Basic Settings Page Parameters
Parameter Description
OSPF Status This parameter specifies the global status of the protocol in the switch.
Router ID This parameter specifies the router identifier.
Autonomous System
Border Router
This parameter indicates the flag to denote whether or not the router is to be
configured as an Autonomous System Border Router.
RFC 1583
Compatibility
This parameter specifies the compatibility to RFC 1583 for choosing the route
among multiple AS for the same destination.
NSSA
ASBR-Default-Route
Translator
This parameter allows you to either Enable or Disable the NSSA
ASBR-Default-Route Translator.
ABR-type
This parameter allows you to choose to configure ABR-type as Standard, CISCO
or IBM
NSSA
ASBR-Default-Route
Translator
This parameter allows you to either Enable or Disable the NSSA
ASBR-Default-Route Translator.
ABR-type This parameter allows you to configure ABR-type as Standard, CISCO or IBM