1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-108
Link Tracking
Clicking the LINK TRACKING link brings up the LINK STATUS TRACKING/CONFIGURE NEW
G
ROUP page (Figure 5-87), which allows you to set the filter configuration to control the
multicast packets that the switch needs to process. The parameters for this page are
shown in Table 5-70.
Figure 5-87. Link Status Tracking/Configure New Group Page
Table 5-70. Link Status Tracking/Configure New Group Page Parameters
Parameter Description
Link Status Tracking This parameter allows you to ENABLE and DISABLE Link Status Tracking.
Configure New Group
This parameter allows you to set the GROUP ID, UPSTREAM INTERFACES and
D
OWNSTREAM INTERFACES for a new group.
Group ID
This parameter specifies the group Id. The group identifiers should be valid
number between 1 to 1024.
Upstream Interfaces
Each group can have one or more upstream interfaces. Physical ports (Gi/Ex)
and port channel interfaces can be configured as upstream ports.
Downstream
Interfaces
Each group can have one or more upstream interfaces. Physical ports (Gi/Ex)
and port channel interfaces can be configured as upstream ports.
Status This specifies the current status of link tracking up or down.
To Next Page
Loading...
