1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-156
Route Aggr
Clicking the ROUTE AGGR tab brings up the BGP ROUTE AGGREGATION CONFIGURATION
page (Figure 5-131), which is used to aggregate and configure the routes advertised by
BGP. The parameters for this page are shown in Table 5-112.
Table 5-111. BGP Filter Configuration Page Parameters
Parameter Description
Filter ID
This parameter specifies the filter index. The allowed value ranges between 1
and 10.
Remote AS
This parameter specifies the remote AS associated with the BGP peer from
which the router is being distributed. The allowed value ranges between 0 and
65535.
IP Address This parameter specifies the IP address for which the route is being learned.
IP Address Prefix
Length
This parameter specifies the prefix length to calculate the Subnet. The allowed
value ranges between 0 and 32.
Intermediate AS This parameter represents the intermediate AS between the BGP peers.
Direction This parameter indicates the direction of the packet.
Action
With this parameter you can choose either to Allow (not to filter) or Deny (Filter)
for the above configuration set.
Status This parameter specifies the status of the entry.
Figure 5-131. BGP Route Aggregation Configuration Page
To Next Page
Loading...
