1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-136
Area
Clicking the AREA tab brings up the OSPF AREA CONFIGURATION page (Figure 5-115).
The parameters for this page are shown in Table 5-96.
Default External
Route
This parameter allows you to Enable or Disable the Default External Route.
Default External
Route Metric
This parameter specifies the External Route Metric in range 0 to 16777215. The
default value is 10.
Default External
Route Metric Type
This parameter allows you to choose to configure the default route metric type as
“1” or “2”.
External Link State
Database Limit
This parameter specifies the maximum number of non-default AS-external-LSA
entries that can be stored in the link state database.
Figure 5-115. OSPF Area Configuration Page
Table 5-96. OSPF Area Configuration Page Parameters
Parameter Description
Area ID This parameter specifies the identifier for the area.
Type
This parameter allows you to configure the area type, as a Stub area, a Normal
area or NSSA.
Table 5-95. OSPF Basic Settings Page Parameters (Continued)
Parameter Description
To Next Page
Loading...
