EasyManua.ls Logo

Supermicro SSE-G24-TG4 - VLAN Interface

Supermicro SSE-G24-TG4
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-111
Chapter 5: Web Based Management Utility
IP
The IP link enables you to perform IP related configuration. This can be done through
the following pages.
VLAN Interface
IPv4 AddrConf
IP Route
LoopBack Settings
VLAN Interface
Clicking the VLAN INTERFACE tab brings up the VLAN INTERFACE BASIC SETTINGS page
(Figure 5-90), which allows configuring of L3 VLAN interfaces. The parameters for this
page are shown in Table 5-72.
Figure 5-90. VLAN Interface Basic Settings Page
Table 5-72. VLAN Interface Basic Settings Page Parameters
Parameter Description
VLAN Interface This parameter specifies the VLAN identifier.
Admin State This parameter specifies the admin state as either Up or Down.
MTU
This parameter specifies the maximum transfer unit size in bytes. The allowed
value ranges from 1500 to 9216. The default value is 1500.

Table of Contents

Other manuals for Supermicro SSE-G24-TG4

Related product manuals