5-13
Chapter 5: Web Based Management Utility
Management IP
Clicking the MANAGEMENT IP tab brings up the MANAGEMENT IP page (Figure 5-4). This
page helps you to manage the IP address for the switch. This page allows configuration
of the following settings:
• IP Address Mode —
This can be either manual or dynamic. If the manual mode is
selected, then the management interface takes the configured IP address as the
Default IP Address.
• IP Address —
Configures the management IP address. This is configurable only if
the IP Address Mode is manual.
• Subnet Mask —
Configures the management IP subnet mask. This is configurable
only if the IP Address Mode is manual.
• Default Mgmt Gateway —
Configures the default gateway IP address in blade
switches. In TOR switches, gateway IP configuration is not supported; instead the
gateway IP address can be specified using the “ip route” configuration.
You can set the switch to D
YNAMIC MODE or MANUAL MODE. If you set the switch to
D
YNAMIC MODE, then it will automatically obtain the IP Address and subset mask from
the DHCP Server. If you set the switch to M
ANUAL MODE, then you can set the IP
Address and subnet mask to whatever setting are appropriate to your network. The
switch is set to 192.168.100.102 for IP Address and 255.255.255.0 for the Subnet Mask
by default.
Figure 5-4. Management IP Page
To Next Page
Loading...
