5-147
Chapter 5: Web Based Management Utility
Transit Delay
This parameter indicates the estimated number of seconds to transmit a link
state update packet over the interface. The allowed value ranges between 0 and
3600.The default value is 1.
Retransmission
Interval
This parameter indicates the number of seconds between the link-state
advertisement retransmissions, for adjacencies belonging to the interface. The
allowed value ranges between 0 and 3600. The default value is 5.
Hello Interval
This parameter indicates the length of time, in seconds, between the Hello
packets that the router sends on the interface. The allowed value ranges
between 1 and 65535. The default value is 10.
Dead Interval
This parameter specifies the number of seconds for which the router waits for
hello packet from the neighbor before declaring this neighbor down. The allowed
value ranges between 0 and 2147483647.The default value is 40.
Poll Interval
This parameter denotes the larger time interval, in seconds, between the Hello
packets sent to an inactive non-broadcast multi- access neighbor.
Demand Procedures
This parameter indicates whether Demand OSPFv3 procedures must be
performed on this interface.
Metric Value
This parameter specifies the metric assigned to this interface. The allowed value
ranges between 0 and 16777215. The default value is 10.
Neighbour Probing
This parameter enables or disables neighbor probing to determine whether the
neighbor is active or inactive.
Neighbour Probe
Retransmit Limit
This parameter indicates the number of consecutive LSA retransmissions before
the neighbor is deemed inactive and the neighbor adjacency is brought down.
The default value is 10.
Demand Probe
Interval
This parameter defines how often the neighbor is probed. The default value is
120.
Table 5-104. Interface Settings Page Parameters (Continued)
Parameter Description
To Next Page
Loading...
