3-7
Chapter 3: Installation and Setup
For example tftpaddr=192.168.2.100
9. Configure the gateway address to reach the TFTP server using the following
command if the TFTP server is in a different network:
gateway=<gateway IP>
For example gateway=192.168.2.100
10. Configure the firmware image file name using the following command:
ramdiskname=<filename>
For example ramdiskname= SBM-GEM-X2C-v5.2.10.bin
11. Type Save to save the hardware information.
12. Type Exit to exit the hardware information menu.
13. Type F to download the firmware image. In this case it will download to the normal
image area.
14. On a successful download, the switch displays the below string.
Updating the ramdisk image ...
This may take awhile
OK
15. After a successful download, boot the switch to use this latest firmware by typing J.
16. If the download fails, check the IP address, file name, network connections and
configurations to reach the TFTP server.
To Next Page
Loading...
