Suzuki AN400 - Page 292

2B-5 Front Suspension:
9) Remove the spring (13) from the oil lock piece (14).
Assembly
Assemble the front fork in the reverse order of
disassembly. Pay attention to the following points:
CAUTION
!
• Thoroughly wash all the component parts
being assembled.
Insufficient washing can result in oil
leakage or premature wear of the parts.
• When reassembling the front fork, use new
fork oil.
• Use the specified fork oil for the front fork.
• When reassembling, replace the slide
metal, guide metal, oil seal, dust seal and
cylinder bolt gasket with the new ones.
• Use care not to cause damage to the slide
metal surfaces since the surfaces are
teflon coated.
Oil lock piece
• Install the spring (1) into the oil lock piece (2) securely.
Inner tube
• Apply fork oil to the guide metal and oil seal lip.
: Fork Oil 99000–99044–10G (FORK OIL or
equivalent)
• Install the following parts onto the inner tube.
– Oil seal (1)
– Oil seal retainer (2)
–Guide metal (3)
CAUTION
!
When installing the oil seal to inner tube, be
careful not to damage the oil seal lip.
• Hold the inner tube vertically, clean the metal groove
and install the slide metal by hand.
CAUTION
!
Do not damage the Teflon coated surface of
the inner tube’s slide metal when mounting it.
• Apply fork oil to the slide metal.
: Fork Oil 99000–99044–10G (FORK OIL or
equivalent)
13
14
I705H1220032-02
1
2
I705H1220013-01
1
2
3
I705H1220014-02
I649G1220021-01