Suzuki AN400 - Page 399

Automatic Transmission: 5A-13
8) Remove the O-ring (8) and oil seal (9).
9) Remove the oil seal (10).
10) Remove the needle bearing (11) using the special
tool.
Special tool
(C): 09921–20240 (Bearing remover set)
11) Remove the snap ring.
12) Remove the bearing using the special tool.
Special tool
(D): 09913–70210 (Bearing installer set)
Assembly
Refer to “Clutch Shoe and Movable Driven Face Parts
Inspection (Page5A-16)”.
1) Install the bearing (1) to the fixed driven face (2)
using a spacer, the size being appropriate for outside
diameter of the bearing.
CAUTION
!
Use a new bearing.
2) Install the snap ring.
CAUTION
!
Use a new snap ring.
9
8
I705H1510041-01
10
I705H1510042-01
11
(C)
I705H1510043-03
I705H1510044-01
(D)
I705H1510064-02
2
1
I705H1510045-02
I705H1510046-01