Suzuki AN400 - Page 400

5A-14 Automatic Transmission:
3) Install needle bearing (3) using a spacer, the size
being appropriate for the outside diameter of the
bearing.
CAUTION
!
• Use a new bearing.
• The stamp mark on the needle bearing
should face outside when installed.
4) Apply the grease both to the bearing and needle
bearing.
CAUTION
!
Fill sufficient grease in the grease groove
inside the fixed driven face and also on the
needle bearing.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5) Install the oil seal (4) and O-ring (5) to the movable
driven face.
CAUTION
!
Use a new oil seal and O-ring.
6) Apply the grease both to the lip of oil seal and O-
ring.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
7) Apply the grease in the grease groove of movable
driven face (6) and sliding face.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
8) Assemble the movable driven face (6) to the fixed
driven face (2).
3
I705H1510047-01
I705H1510048-01
4
5
I705H1510049-01
6
I705H1510050-01
6
2
I705H1510051-05