Service Data: 0C-3
Transmission
Unit: mm (in) Except ratio
Injector + Fuel Pump + Fuel Pressure Regulator
FI Sensors
Item Specification Note
Primary reduction ratio 1.000 —
Reduction ratio 2.200 – 0.839
Secondary reduction ratio 2.214 —
Final reduction ratio 2.666 —
Drive V-belt width 25.1 (0.99) 24.1 (0.95)
Movable driven face spring free
length
150.0 (5.90) 142.5 (5.61)
Movable drive face roller O.D. 26.00 – 26.16 (1.024 – 1.030) —
Drive/driven face ware — 0.4 (0.02)
Item Specification Note
Injector resistance Approx. 10.3 Ω at 20 °C (68 °F) —
Fuel pump discharge amount
35 ml and more
For 10 sec., at 300 kPa (3.0 kgf/cm
2
, 43 psi)
—
Fuel pressure regulator operating
set pressure
Approx. 300 kPa (3.0 kgf/cm
2
, 43 psi) —
Item Specification Note
CKP sensor resistance 190 – 290 Ω
CKP sensor peak voltage 4.5 V and more (When cranking)
(+) probe: G/W,
(–) probe: Bl
IAP sensor input voltage 4.5 – 5.5 V
IAP sensor output voltage Approx. 1.5 – 3.5 V at idle speed
TP sensor input voltage 4.5 – 5.5 V
TP sensor output voltage
Closed Approx. 0.6 V
Opened Approx. 3.8 V
ECT sensor input voltage 4.5 – 5.5 V
ECT sensor resistance Approx. 2.58 kΩ at 20 °C (68 °F)
IAT sensor input voltage 4.5 – 5.5 V
IAT sensor resistance Approx. 2.58 kΩ at 20 °C (68 °F)
TO sensor resistance 16.5 – 22.3 kΩ
TO sensor output voltage
Normal 0.4 – 1.4 V
Leaning 3.7 – 4.4 V
Injector voltage Battery voltage
Ignition coil primary peak voltage 150 V and more (When cranking)
(+) probe: W,
(–) probe: Ground
HO2 sensor resistance 11.5 – 14.5 Ω at 23 °C (73.4 °F)
HO2 sensor output voltage
Idle speed 0.3 V and less
3 000 r/min 0.7 V and more
STP sensor input voltage 4.5 – 5.5 V
STP sensor output voltage
Closed Approx. 0.5 V
Opened Approx. 3.9 V
STP actuator resistance Approx. 6.5 Ω
To Next Page
Loading...
