Engine Mechanical: 1D-13
CAUTION
!
Never separate the throttle bodies, left and
light.
CAUTION
!
Never remove the throttle valve (15) and
secondary throttle valve (16).
CAUTION
!
These adjusting screws (17), (18) are factory-
adjusted at the time of delivery and therefore
avoid removing or turning them unless
otherwise necessary.
Assembly
Assembly is the throttle body in the reverse order of
removal. Pay attention to the following points:
• Apply thin coat of the engine oil to the O-ring.
• With the STV fully closed, install the STP sensor (1)
and tighten the STP sensor mounting screw to the
specified torque.
NOTE
• Align the secondary throttle shaft end “A”
with the groove “B” of STP sensor.
• Apply grease to the secondary throttle
shaft end “A” if necessary.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
STP sensor mounting screw: 3.5 N·m (0.35 kgf-
m, 2.5 lbf-ft)
NOTE
Make sure the STP valve open or close
smoothly. If the STP sensor adjustment is
necessary, refer to “STP Sensor Adjustment
in Section 1C (Page 1C-4)”.
I718H1140332-01
15
16
I718H1140333-03
17
18
I718H1140334-02
1
“A”
“B”
I718H1140335-01
I718H1140336-01
To Next Page
Loading...
